FibertecTM 8000

Fibertec™ 8000 is a fully automated system for determination of crude fibre, detergent fibre and related parameters according to standard reference ‘crucible’ methods such as Weende, van Soest etc.

Call On: 9136909578

Sales Support: sales.mfd@labindia.com

Service Support: servicecoordinator@labindia.com

Typical Specification

Performance data

Sample size

0.5 - 3 g

Measuring range

0.1% - 100%

Capacity per batch

Up to 6 samples simultaneously

Capacity per day

Up to 36 analyses (Crude Fibre method).
Up to 60 analyses using modified procedure

Repeatability

±1 % relative at 5% - 30% fibre level N

Reagent preheating time

10 - 12 minutes

Heating-up time from preheated
temperature to boiling

5 - 7 minutes

Installation requirements

Equipment

Power supply

Power consumption

Dimensions w × d × h cm

Weight

Water supply

FibertecTM 8000
Hot Extraction Unit

230 V
50/60 Hz

2.000 W

73 × 39 × 64

67 kg

*Tap water minimum 2 l/min
(4-25ºC, depending on water
pressure)

FT 121 FibertecTM
Cold Extraction Unit
with water aspirator

56 × 38 × 28

14 kg

Tap water 2 l/min

Note:
Cold Extraction Unit must be placed in the fumehood with at least 0,5 m/sec airflow. * When FibertecTM 8000 is in standby mode the tap water supply is closed down.

Standard Features of Cryogenic Ball Mill CM1100

Tank for titrant, complete with tubing
Burette Dosing device for calibration of burette
Top loaded level sensor for waste tank
Top loaded level sensor for reagent tank
Tank 20 l (Alkali/water/waste) without level sensors
Level sensor kit for waste
Level sensor kit for reagentfa-spin
Adapter for Büchi tubes
Handling device for digestion tubes

LABINDIA reserve the right to change specification without notice as part of its continuous product development.

Foss

Kjeltec9-Analyser Kjeltec9-Distillator KT-200-Kjeltec Kjeltec-8100 Kjeltec-8200 Kjeltec-8400 Dumatec-8000

FibertecTM 8000

Note:Cold Extraction Unit must be placed in the fumehood with at least 0,5 m/sec airflow. * When FibertecTM 8000 is in standby mode the tap water supply is closed down.

Note:
Cold Extraction Unit must be placed in the fumehood with at least 0,5 m/sec airflow. * When FibertecTM 8000 is in standby mode the tap water supply is closed down.